Emergency CR Repair - Take About 9 Inches of #22 Stranded Wire And Solder Round Lugs On Each End
See Randy's Keyboard Filter Repair And RG-174 Replacement Here
http://www.comcents.com/tty/tty5.html
See Randy's Auto Typer Overhaul Here
http://www.comcents.com/tty/tty.php
Meguiar's Cleaner Wax Does Wonders
How To Make Your Name Plates Look Better - Make Sure Plate Is Straight As Possible And Clean It With Lacquer Thinner - Next Spray Plate With Two Or Three Lightly Coats Of Glossy Black Paint - Let Dry - Next Find A Flat Surface To Work On - Take 600 Grit Emery Paper And Place Up On Flat Surface - Take Dried Name Plate And Place Down On Emery Paper - Slowly Rotate Plate On Paper With Two Fingers And Check The Progress Of Your Efforts Often - Remove All Areas That Still Have Black Paint Untill All The Raised Surfaces Show Brass And The Back Ground Is Still All Black - If One Presses Too Hard Or For Too Long Then The Background Areas Will Be Showing Brass - If You Are Lucky, You Can Start Over And Try Again - Work With Light Pressure Check Offen Provides The Best Results - Once Completed One Can Spray With Clear Coat To Prevent The Brass From Becoming Dull With Age
